The TD25 / TD25F thermodynamic steam trap extends the disc principle to higher pressure and more severe duty than the TD16. It is specified on high pressure steam mains, superheated steam, and plant where the trap is exposed to pressure cycling and vibration.
The F version carries an integral strainer, which protects the seating face on new or dirty pipework and on mains where scale is expected after a shutdown.
Design and construction
Heavier stainless steel body and a hardened disc lapped to the seat, designed for the higher pressure class. The disc responds to the velocity of the flashing condensate rather than to a float, so there are no mechanical linkages to wear and no water body to freeze.
Key features
- Higher pressure rating than the TD16 for severe mains duty
- Hardened disc and lapped seat for tight shut-off at pressure
- Tolerant of superheat, water hammer and pressure cycling
- Freeze-proof – no condensate body to burst
- TD25F with integral strainer for dirty or new pipework
- Very few wearing parts, low lifetime cost
Selection and sizing
Select TD25/TD25F where the main pressure is above the TD16 range, where superheat is present, or where the trap has a history of erosion and leakage. Confirm the differential pressure and back pressure ratio, and check that the discharge pipework and manifold are rated for the flash steam.
Installation and maintenance
Install at the low point of the main with the inlet above the disc, keep the discharge free-draining and insulate the body. On superheated steam, allow for the higher temperature at the seat and specify the correct disc grade. Fit a sight glass at commissioning to verify cycling.
Options and spare parts
Discs, strainer screens and body gaskets are available; the body is normally retained for the plant life.