KE73 PN16 two-way pneumatic control valve for steam and process temperature control

KE73 PN16 Two-Way Control Valve

PN16 two-port control valve for steam, water and process fluids - linear or equal percentage trim

The KE73 is a PN16 two-port control valve for modulating steam, hot water and process duties. It is the final control element in a temperature, pressure or flow loop: the actuator strokes the plug in response to a controller signal, and the plug position sets the flow through the valve.

The valve is normally supplied with a linear or equal percentage characteristic. Steam duties take the equal percentage plug, because it gives finer control at low load when the pressure drop across the valve is large; water and constant-drop duties take the linear plug.

Design and construction

Single-seat, stem-guided globe body with a bolted bonnet, PTFE or graphite packing and a stainless steel plug and seat. The body is rated PN16 with flanged connections to EN 1092. The stem accepts pneumatic diaphragm actuators, electric actuators and hand wheels, so the same body covers a wide range of plant standards.

Key features

  • DN15 – DN100 body range covering most steam and water duties
  • Linear or equal percentage plug characteristic
  • PN16 flanged body to EN 1092, cast iron or ductile iron
  • Stainless steel trim resistant to steam erosion
  • Accepts pneumatic, electric or manual actuation
  • Low-lead, tight-closing single seat design

Selection and sizing

Size the valve on the required flow and the pressure drop available at the valve, then check the result against the body size – a control valve that is too large will hunt and wear its seat. For steam, take the critical pressure ratio into account and select the equal percentage plug. State the medium, flow rate, upstream pressure, downstream pressure and temperature when requesting a quotation, together with the actuation (pneumatic with positioner, electric or manual).

Installation and maintenance

Install with flow in the direction of the arrow, with a strainer upstream and isolation valves either side. Leave straight pipe runs before and after the valve and allow space for the actuator to be removed. On steam, fit a separator or trap set upstream so the valve sees dry steam, which is what determines seat life.

Options and spare parts

Plugs, seats, packing sets, gaskets and complete actuator assemblies are available; state the valve size, trim characteristic and Cv when ordering.

Request a Quote

Technical Specifications

Standard configurations. Custom materials, connections and special testing available on request.

ParameterSpecification
Product type Two-port (two-way) control valve
Size range DN15 - DN100
Connections Flanged EN 1092 PN16
Body material Cast iron / ductile iron
Nominal pressure PN16
Max operating temperature (TMA) 300 °C (packing dependent)
Trim Stainless steel plug and seat; linear or equal percentage
Actuation Pneumatic diaphragm, electric actuator or manual hand wheel
Testing Shell and seat test to EN 12266
Documentation EN 10204 3.1 material certificate

Typical Applications

Steam & Fluid Control

Modulating control valves, actuators and positioners for accurate process control loops.

Pressure Management

Pressure reducing and safety relief valves protecting steam and compressed air systems.

Plant Automation

Electric and pneumatic actuation for remote and hazardous-area valve operation.

Related Control Systems

Compare more products in the same range.

Get KE73 PN16 Two-Way Control Valve Pricing Today

Send us your size, class and material requirements - quotation within 24 hours.

Request a Quote