MFP14-PPU pressure powered condensate pump unit for boiler feed and heat recovery

MFP14-PPU Condensate Pump

Pressure powered condensate pump unit - complete package for condensate return

The MFP14-PPU is a pressure powered condensate pump unit: a pump trap supplied as a package with the receiver, valves and connections needed to return condensate to the boiler house. It is the practical way to install condensate recovery on a plant where the return main is lifted or pressurized.

Recovering hot condensate saves three times over: the water, the treatment chemicals and the heat it carries. A pump unit that works without an electric motor and without cavitation is the enabling device for that recovery.

Design and construction

Receiver with a float-operated cycling mechanism, motive steam or air connections, non-return valves and a packaged frame that simplifies installation. The unit is designed to sit at the low point of the condensate system and discharge to a high level or a pressurized main.

Key features

  • Complete packaged unit – receiver, valves and connections
  • No electric pump and no cavitation at high condensate temperature
  • Returns hot condensate to the feed tank or deaerator
  • Float-operated cycling suits variable loads
  • Suitable for hazardous and remote areas
  • Reduces water, chemical and fuel consumption

Selection and sizing

Provide the condensate flow, the available motive pressure, the total lift and the return main pressure. Check the unit against the worst case – start-up with a cold plant often produces the largest condensate flow. Two units in parallel give continuity where the load is critical.

Installation and maintenance

Set the unit at the lowest point of the drainage system, with gravity feed from the equipment and a strainer upstream. Pipe the motive gas from a reliable source, fit a vent at the receiver, and support the discharge pipework independently.

Options and spare parts

Float mechanisms, valve assemblies, gaskets and non-return valves are available as spares.

Request a Quote

Technical Specifications

Standard configurations. Custom materials, connections and special testing available on request.

ParameterSpecification
Product type Pressure powered condensate pump unit (packaged)
Motive gas Steam or compressed air
Connections Flanged, EN 1092
Body material Cast iron / steel receiver
Max operating pressure (PMA) 13 bar g (motive dependent)
Max operating temperature (TMA) 200 °C
Configuration Receiver, valves, non-return valves, frame
Documentation EN 10204 3.1 material certificate

Typical Applications

Condensate Return

Pressure and electrically powered pumps returning hot condensate to the boiler feed system.

Energy Recovery

Recover flash steam and condensate heat to lower fuel and water treatment costs.

Related Condensate & Heat Recovery

Compare more products in the same range.

Get MFP14-PPU Condensate Pump Pricing Today

Send us your size, class and material requirements - quotation within 24 hours.

Request a Quote