The SV607 is a ductile iron safety relief valve for steam, hot water and air systems in the utility pressure range. Ductile iron gives a tougher body than grey cast iron at a lower cost than carbon steel, which suits boiler houses, steam distribution, calorifiers and compressed air receivers.
It provides a certified, repeatable set pressure and a positive pop action, so the discharge capacity assumed in the vessel’s relief calculation is actually available when the valve lifts.
Design and construction
Bonnet-type valve with a ductile iron body, stainless steel disc and seat, and a spring set and locked at the required pressure. The guided disc gives a stable lift and reseats cleanly after discharge, which matters on steam where a leaking safety valve is both a heat loss and a hazard.
Key features
- Ductile iron body – tougher than grey iron, economical
- Certified set pressure with positive pop action
- Stainless steel disc and seat for steam service
- Clean reseat after discharge
- Suitable for steam, hot water and compressed air
- Lever for periodic lifting test
Selection and sizing
Size on discharge capacity at the set pressure, allowing for back pressure on the outlet. Confirm the design pressure of the protected equipment, the allowable overpressure and the required standard. For steam above the ductile iron rating, use the carbon steel SV604.
Installation and maintenance
Install vertically on the vessel or on a short direct connection, with no isolating valve between the vessel and the valve. Discharge to a safe location and drain any condensate that could collect at the outlet. Test-lift the valve at commissioning and at the intervals required by the plant inspection schedule.
Options and spare parts
Discs, seats, springs and gaskets are available; set pressure must be re-tested after any reconditioning.