The packaged steam heat exchange unit is a complete steam-to-liquid heater: heat exchanger, control valve, trap set, strainer, safety valve and controls assembled on a frame and tested before dispatch. It removes the engineering and the site assembly from a heat transfer project.
The alternative – specifying an exchanger, a control valve, a trap set and the controls separately – leaves the interfaces to the installer, and interfaces are where packaged units earn their cost back.
Design and construction
Shell and tube or plate exchanger with a steam control valve, condensate trap set, strainer, safety valve and a control panel on a common frame. Units are factory tested for pressure integrity and control function before shipment.
Key features
- Complete unit – exchanger, controls, trap set and safety valve
- Factory assembled and tested before dispatch
- Steam to hot water or process liquid heating
- Modulating control for accurate outlet temperature
- Reduced site work and fewer interface risks
- Documentation package for the whole assembly
Selection and sizing
Provide the duty: fluid, flow rate, inlet and outlet temperature, steam pressure available and the allowable pressure drop. Confirm the materials for the process fluid, and whether the unit must meet a particular pressure vessel code or carry third-party inspection.
Installation and maintenance
Site the unit on a level foundation with access for tube or plate cleaning, connect steam, condensate, process fluid and drain connections as marked, and commission the controls against the design duty. Check the safety valve is set and certified before the unit is pressurized.
Options and spare parts
Gaskets, plates or tube bundles, control valve trim and trap internals are available as spares.