The FT44 takes the ball float principle into higher pressure and temperature service. The carbon steel body and welded or flanged connections allow it to be used on process steam where cast iron traps would be outside their rating – typically above 13 bar g or where thermal cycling and water hammer loading are present.
It is specified on refinery, petrochemical, power house and large process steam systems where a trap must hold pressure without leaking, discharge continuously and survive years of cycling without a body failure.
Design and construction
Carbon steel body with a bolted or welded cover, stainless steel float and lever, and a hardened valve plug working against a replaceable seat. The heavier section and higher rating suit mains that see pressure transients at start-up and shutdown.
Key features
- Carbon steel body for high pressure and high temperature steam
- Continuous discharge protects heat transfer and avoids condensate backup
- Hardened seat and plug resist erosion at high differential pressure
- Suitable for superheated and thermally cycled process steam
- Flanged or welded connections to match plant pipe classes
- Replaceable internals extend service life without pipework changes
Selection and sizing
Select the FT44 where the steam pressure exceeds the cast iron limit, where the trap sees repeated thermal cycling, or where a body failure would be a safety issue. Confirm PMA at the maximum pressure and TMA at the maximum temperature simultaneously; size the orifice on the minimum differential pressure at the trap.
Installation and maintenance
Provide a strainer upstream and a sight glass downstream. On high pressure mains, install a bypass valve so the trap can be isolated and serviced without a plant shutdown. Check that the discharge pipework is rated for the flash steam produced at the trap outlet.
Options and spare parts
Float and lever assemblies, seats, plugs, gaskets and cover bolts are available for all sizes.