The FT14 screwed ball float steam trap is the compact version for small steam equipment: unit heaters, small jacketed pans, tracing lines, laundry and food equipment, and packaged plant where a screwed joint is simpler and cheaper than a flange.
It uses the same float-operated mechanism and the same stainless steel internals as the flanged version, so performance and spare parts are identical – only the connection changes.
Design and construction
SG iron body with screwed BSP or NPT tappings, bolted cover and stainless steel float, lever and valve plug. The screwed body is shorter and lighter than the flanged equivalent, which suits tight installations and retrofits where the existing pipework is threaded.
Key features
- Screwed BSP or NPT connections for fast installation and retrofit
- Same float mechanism as the flanged FT14 – identical spares
- Continuous discharge with three orifice options
- Compact body for tight plant rooms and skid installations
- Stainless steel internals for long orifice life
- Suitable for unit heaters, tracing lines and small process equipment
Selection and sizing
Use the screwed FT14 where the line size is DN25 or below and the pipe class permits a threaded joint. Above DN25, or where plant standards require flanges, use the flanged version. Size on the condensate load and minimum differential as for the flanged trap, and specify the orifice grade explicitly.
Installation and maintenance
Use a strainer immediately upstream and a sight glass downstream. Support the pipework so the trap body is not carrying bending load, and leave access for the cover to be removed. On tracing lines, fit the trap at the lowest point and keep the line falling towards it.
Options and spare parts
Identical spares to the flanged FT14: float and lever assembly, plug, seat and cover gasket, in all sizes.