The TFA is a steam flowmeter for measuring mass flow in a main, a process block or a boiler outlet. Accurate steam measurement underpins energy accounting, boiler efficiency checks and the identification of the lines where steam is being lost.
Because steam is compressible and its density changes with pressure, a steam meter needs pressure and temperature compensation to report mass flow rather than volume. The TFA is supplied with the compensation arrangement appropriate to the duty.
Design and construction
Flow sensor with a transmitter that computes mass flow from the measured signal plus pressure and temperature inputs. The meter is configured at the factory for the specified range and steam conditions.
Key features
- Mass flow measurement with pressure/temperature compensation
- Digital output for the control system or energy dashboard
- Wide turndown for varying loads
- Suitable for saturated and superheated steam
- Factory configured for the specified range
- Supports boiler efficiency and cost allocation reporting
Selection and sizing
Provide the normal and maximum flow in kg/h, the pressure and temperature at the meter, the pipe size and the material, and the required output. Sizing on the maximum flow alone gives poor accuracy at low load, which is where most steam is wasted.
Installation and maintenance
Observe the upstream and downstream straight length requirements, fit a strainer upstream and insulate the pipe. Ensure the transmitter and any pressure/temperature tappings are accessible for calibration.
Options and spare parts
Transmitters, sensors and gaskets are available; calibration certificates are supplied with each meter.