The SV615 is a bronze, screwed safety valve for small steam and hot water plant: package boilers, calorifiers, hot water cylinders, small receivers and steam-heated equipment. It is compact, inexpensive and available in the small sizes those duties use.
Bronze construction is appropriate for clean, non-corrosive steam and water at utility pressures, and the screwed connections allow it to be fitted directly to small vessels without adaptors.
Design and construction
Bronze body with a lapped stainless or bronze disc, a spring set and locked at the required pressure, and a lever for manual lifting. The screwed inlet and outlet suit small-bore pipework and direct mounting on the protected vessel.
Key features
- Bronze body for clean steam and hot water service
- Small sizes with screwed connections for direct mounting
- Certified set pressure, locked at the works
- Lever for periodic lifting test
- Compact and economical for package plant
- Clean reseat to avoid steam loss after discharge
Selection and sizing
Confirm the set pressure against the vessel’s design pressure and the discharge capacity against the heat input of the boiler or calorifier – a safety valve that is too small will not pass the required steam. Use bronze only for non-corrosive duties; for higher pressure or aggressive fluids move to the SV604 or SV607.
Installation and maintenance
Mount vertically, directly on the vessel where possible, with no valve between the vessel and the safety valve. Route the discharge safely and avoid any condensate pocket at the outlet. Lift-test at commissioning and record the set pressure.
Options and spare parts
Discs, springs and gaskets are available; the body is normally retained.