The EP5 is an electro-pneumatic positioner that converts a 4-20 mA controller signal into a pneumatic output to the actuator. It closes the loop on valve position rather than on air pressure, so stem friction, packing wear and supply variations no longer translate into control error.
Fitting a positioner is the single most effective upgrade on a pneumatically actuated control valve: it removes hysteresis and stick-slip, and it makes the valve respond to small signal changes that a bare actuator ignores.
Design and construction
Balanced beam or feedback potentiometer sensing the stem position, with a nozzle-flapper or piezo pilot stage and adjustable zero and span. Auto-calibration routines set the stroke ends in a few minutes, and the housing is sealed for plant environments.
Key features
- 4-20 mA input with accurate stem position control
- Removes actuator hysteresis and stick-slip
- Auto calibration for fast commissioning
- Adjustable zero and span
- Split range and reverse action available
- Sealed housing for indoor and outdoor plant
Selection and sizing
Specify the actuator it will be fitted to, the supply air pressure, the desired action (direct or reverse) and whether split range is needed. Confirm the input signal and any requirement for an I/P converter where only a pneumatic signal is available.
Installation and maintenance
Mount the positioner on the actuator with the feedback linkage correctly aligned, then run auto calibration before putting the loop in service. Use clean, dry instrument air – oil and water in the air line are the usual cause of positioner faults.
Options and spare parts
Feedback linkages, pilot assemblies and filter regulators are available as spares.