The SM45 is a bimetallic steam trap. A stack of bimetal elements bends as it heats, closing the valve when steam reaches the trap and opening it when condensate cools. Because the set point is adjustable, the trap can be tuned to hold back a deliberate amount of subcooling and so recover sensible heat that other trap types discharge to the return main.
It is the trap to specify where steam is superheated, where pressure is high, where water hammer is a problem, or where energy saving from subcooled discharge matters – typically large steam mains, turbine exhaust and high temperature process plant.
Design and construction
Steel body with a bimetal element stack and an adjusting screw that sets the discharge temperature. There is no float, no orifice plate and no sealed capsule, so the trap is immune to water hammer and to freezing, and it tolerates superheat without damage.
Key features
- Adjustable subcooling to recover sensible heat from condensate
- Immune to water hammer and to freezing
- Handles superheated steam without damage
- No float or sealed capsule to fail
- Blowdown screw for cleaning the seat in place
- Long service life on high pressure mains
Selection and sizing
Choose the SM45 for superheated or high pressure steam, or where condensate is discharged to a high back pressure. Set the adjustment so the trap discharges a few degrees below steam temperature – too much subcooling floods the equipment, too little wastes heat. Bimetallic traps respond slowly, so they are not ideal for fast-cycling loads.
Installation and maintenance
Install with flow in the direction of the arrow, ideally with the body horizontal, and allow access to the adjusting screw. Fit a strainer upstream. Commission by measuring the discharge temperature at the sight glass and adjusting to the specified subcooling.
Options and spare parts
Bimetal element assemblies, seats and body gaskets are available; the adjusting mechanism is normally retained.